Here you define the properties of the wall layer.

In the dialog box you will find on the left side the Display section with the dynamic preview. On the right side you can see the Operating section with the tabs Layers and Manager.

The preview is primarily intended for visual checks and shows the part with the set properties.

Hatched
Creates a wall layer with hatched infill. When you select a material, the material-dependent hatching is used.

Close wall thickness
Closes the wall thickness with a continuous line. Deactivate the tick box for an interrupted display of the wall layer.

Opens the Dialog box Assign Layer. You will find further information on this in the Chapter Layer assignment.

Opens the Dialog box Assign hatch pattern. You will find further information on this in the Chapter Hatch pattern assignment.

Opens the Dialog box Label. You will find further information on this in the Chapter Labeling.

Thickness
Defines the thickness of the wall layer.

Material
Defines the material for the wall layer. To do this, the Dialog box Material selection is opened. You will find further information on materials in Chapters Material and Material selection.

Item
Opens the Dialog box Item, where you can select an item number. You will find a detailed explanation on items in the Chapter Item.

Chamfer
Activates chamfering for the wall layer. When you activate the tick box, you can specify the chamfer distance in the input field. Chamfers are always applied to each outer corner of the wall layer.

Click OK to adopt the settings made for the wall layer.
Click Cancel to discard the settings made for the wall layer.
In both cases you arrive back at the initial Dialog box Wall manager.