If you want to use assemblies with variants in the drawing, the Dialog box Assembly parameters is displayed. Here, you can set the variant of the assembly which you want to use.
Dialog box Assembly parameters
db_ath_bgr_parm
On the left side the dialog box contains a preview of the current part. If you change the variant, it is immediately displayed.
Dialog box section Display
Preview Determines whether a preview of the assembly is displayed in the dialog box or not.
Plan Shows the plan view of the assembly in the preview.
Side elevation Shows the side elevation of the assembly in the preview.
Front elevation Shows the front elevation of the assembly in the preview.
The settings of the preview have no effects on the insertion of the assembly into the drawing!
Dialog box section Variants
With the help of a maximum of three selection menus you can select the variants with which you want to insert the assembly into the drawing.
The number of active selection menus depends on the number of defined variants of the assembly.