Assigns tags to bars, infills and frame elements of a job. Tags are identifiers which are assigned to the parts. Same-part recognition takes place. Identical parts therefore receive the same identifier so that they can be brought together in the parts list during the analysis.
To assign tags the corresponding parts must have been allocated to a job with the Project browser.
Identical parts receive the same tag, starting with the largest part. When tags are again assigned, for example when the parts list or size of some parts have changed, all the old tags are removed and reassigned. Consequently, the possibility exists where some parts receive different tags after the reassignment.
When you run the command, the Dialog box Projects is opened, where you can select a job or job part. When you close the dialog box with OK after selecting the job, you can assign the tags in the following dialog box.
Dialog box Assign tags
db_ath_tagging_assign
In the top section of the dialog box the job is displayed which was selected in the precedingDialog box Projects.
Dialog box section Objects
Bars Shows all bars of the drawing in the item list. Assigns tags to the selected bars and executes same-part recognition when the dialog box is closed with OK.
Infills Shows all infills of the drawing in the item list. Assigns tags to the selected infills and executes same-part recognition when the dialog box is closed with OK.
Frame elements Shows all frame elements of the drawing in the item list. Assigns tags to the selected frame elements and executes same-part recognition when the dialog box is closed with OK.
.
Always, only the set objects (bars or infills or frame elements) are processed.
Dialog box section Item
Lists the parts contained in the drawing. Only the parts are displayed which have been switched on in the Dialog box section Objects: If you have switched on bars, all bars are displayed, etc. Here, you select a part (for example the mullion) to define the rules for same-part recognition.
Dialog box section Same-part recognition
When you activate the tick box, a tag is assigned to the corresponding parts (for example all mullions).
Start Shows the tag assigned to the first (largest) part.
Further below are shown how many parts and how many dimensions of the part are present in the drawing.
End of program
OK Closes the dialog box and assigns the tags to the parts.
Cancel This closes the dialog box without assigning tags.
